Filters
Close

Supreme Downpipe Rainwater

Display per page

MFP Supreme Branch 112.5 Degree

SQY1BRange
Supreme Pipe Branches are used to connect two downpipes together. They are usually used to bring a pipe run from a lower level roof such as a porch into the main downpipe that drops from the gutter at roof level. Available in black or white.
£11.55 excl vat

MFP Supreme Downpipe Clip

SQC1BRange
MFP Supreme Downpipe Clip for use with the supreme downpipe range. These clips should either be fitted once every 1.5 metres or if your downpipe system is smaller than 4.5 metres then you should have three downpipe clips fixing the downpipe to the wall, equally spaced out. Available in black or white.
£1.89 excl vat

MFP Supreme Hopper

SQH1BRange
Hoppers are used to bring together a collection of flows from different pipes. The bottom of the hopper is then connected to a standard rainwater pipe. No solvent or sealant is required. Hoppers are most commonly found on properties that use a combined drainage system - where both rainwater and foul water from kitchens and bathrooms all flow into the same drainage pipes.
£12.21 excl vat

MFP Supreme Long Downpipe Clip

SQC2BRange
These clips should either be fitted once every 1.5 metres or if your downpipe system is smaller than 4.5 metres then you should have three downpipe clips fixing the downpipe to the wall, equally spaced out.
£1.82 excl vat

MFP Supreme Offset 112.5 Degree

SQB1BRange
Use two of these bends to make a swan neck as required. Available in Black or White.
£3.69 excl vat

MFP Supreme Offset 92.5 Degree

SQB2BRange
Use two of these bends to make a swan neck as required. Available in Black or White.
£4.13 excl vat